Руководство Philips QT4021 Триммер для бороды

Руководство

Introduction

Congratulations on your purchase and welcome to

Philips! To fully benet from the support that Philips offers,

register your product at www.philips.com/welcome.

General description (Fig. 1)

A Beard trimming comb

B Cutting unit

C Precision Zoom Lock ` adjustment ring

D Charging light

E Socket for appliance plug

F On/off slide

G Adapter

H Appliance plug

I Cleaning brush

Important

Read this user manual carefully before you use the

appliance and save it for future reference.

Danger

- Make sure the adapter does not get wet.

Warning

- The adapter contains a transformer. Do not cut

off the adapter to replace it with another plug, as

this causes a hazardous situation.

- This appliance is not intended for use by persons

(including children) with reduced physical, sensory

or mental capabilities, or lack of experience and

knowledge, unless they have been given supervision

or instruction concerning use of the appliance by a

person responsible for their safety.

- Children should be supervised to ensure that they

do not play with the appliance.

Caution

- Use, charge and store the appliance at a temperature

between 5°C and 35°C.

- Only use the adapter supplied.

- Never immerse the appliance in water or rinse it

under the tap.

- If the adapter is damaged, always have it replaced

with one of the original type in order to avoid a

hazard.

- This appliance is only intended for trimming the

human beard. Do not use it for any other purpose.

- Do not use the appliance if the cutting unit or the

beard trimming comb is damaged or broken, as this

may cause injury.

- Noise level: Lc = 64 dB(A).



This Philips appliance complies with all standards

regarding electromagnetic elds (EMF). If handled

properly and according to the instructions in this user

manual, the appliance is safe to use based on scientic

evidence available today.

General

- The appliance is equipped with an automatic voltage

selector and is suitable for mains voltages from 100

to 240 volts.

- The adapter transforms 100-240 volts to a safe low

voltage of less than 24 volts.

Charging

Charge the appliance fully before you use it for the rst

time.

It takes approximately 10 hours to fully charge the

appliance.

When it is fully charged, the appliance has a cordless

operating time of up to 35 minutes.

Note: You can use the appliance cordless as well as

connected to the mains.

1 Make sure the appliance is switched off (Fig. 2).

2 Insert the appliance plug into the appliance (Fig. 3).

3 Put the adapter in the wall socket.

, The charging light on the appliance goes on to

indicate that the appliance is charging.

Note: The charging light does not change colour and does

not go out when the appliance is fully charged.

4 After charging, remove the adapter from the

wall socket and pull the appliance plug out of the

appliance.

Optimising the lifetime of the rechargeable

battery

When you have charged the appliance for the rst time,

we advise you to use it until the battery is completely

empty.

Do not recharge the appliance in between the trimming

sessions.

Continue to use the appliance until the motor almost

stops running during a session. Then recharge the battery.

Follow this procedure at least twice a year.

Trimming

Always comb the beard and/or moustache with a ne

comb before you start trimming.

When you trim for the rst time, be careful. Do not

move the trimmer too fast. Make smooth and gentle

movements.

Trimming with beard trimming comb

1 Turn the Precision Zoom Lock ` adjustment ring

to the desired setting. (Fig. 4)

See the table below for an overview of the settings and

the resulting hair lengths.

Setting Resulting hair length

1 1mm

2 2mm

3 3.5mm

4 5mm

5 7mm

6 9mm

7 11.5mm

8 14.5mm

9 18mm

The setting appears in the window below the Precision

Zoom Lock ` adjustment ring.

Note: When you trim for the rst time, start at the highest

setting (9) to familiarise yourself with the appliance.

2 Switch on the appliance.

3 To trim most effectively, move the trimmer against

the hair growth direction. Make sure the surface

of the comb always stays in contact with the

skin (Fig. 5).

4 If a lot of hair has accumulated in the beard

trimming comb, remove the comb and blow and/or

shake the hair out of it. The selected setting does

not change when you do this (Fig. 6).

Never pull at the exible top of the beard trimming

comb. Always pull at the bottom part.

Trimming at the unique ‘stubble look’ setting

1 To create a ‘stubble look’, trim with the beard

trimming comb set to setting 1 (Fig. 7).

Trimming without beard trimming comb

Use the trimmer without beard trimming comb to trim

full beards and single hairs.

1 Pull the beard trimming comb off the

appliance (Fig. 8).

Never pull at the exible top of the beard

trimming comb. Always pull at the bottom part.

2 Switch on the appliance.

3 Make well-controlled movements. Touch the hair

lightly with the trimmer (Fig. 9).

Corded trimming

If the battery is low, you can also use the appliance from

the mains:

1 Switch off the appliance, insert the adapter in the

wall socket and wait a few seconds before you

switch on the appliance.

Note: If the battery is completely empty, wait a few minutes

before you switch on the appliance.

Cleaning

Never use scouring pads, abrasive cleaning agents or

aggressive liquids such as alcohol, petrol or acetone to

clean the appliance.

1 Make sure the appliance is switched off and

disconnected from the mains.

2 Remove the beard trimming comb.

3 Open the cutting unit (Fig. 10).

4 Clean the cutting unit and the inside of the

appliance with the cleaning brush supplied (Fig. 11).

5 Push the cutting unit back onto the appliance to

close it (‘click’) (Fig. 12).

Note: The appliance does not need any lubrication.

Replacement

Only replace a worn or damaged cutting unit with an

original Philips cutting unit, available from authorised

Philips service centres.

1 Open the cutting unit.

2 Pull the old cutting unit upwards to remove

it (Fig. 13).

3 Insert the two lugs of the new cutting unit into the

guiding slots (Fig. 14).

4 Push the cutting unit back onto the appliance

(‘click’) (Fig. 12).

Environment

- Do not throw away the appliance with the normal

household waste at the end of its life, but hand it in

at an ofcial collection point for recycling. By doing

this, you help to preserve the environment (Fig. 15).

- The built-in rechargeable battery contains substances

that may pollute the environment. Always remove

the battery before you discard and hand in the

appliance at an ofcial collection point. Dispose of

the battery at an ofcial collection point for batteries.

If you have trouble removing the battery, you can

also take the appliance to a Philips service centre.

The staff of this centre will remove the battery for

you and will dispose of it in an environmentally safe

way. (Fig. 16)

Removing the rechargeable battery

Only remove the rechargeable battery if it is completely

empty.

1 Disconnect the appliance from the mains and let

the appliance run until the motor stops.

2 Undo the screw in the housing of the

trimmer (Fig. 17).

3 Separate the 2 housing parts with a

screwdriver (Fig. 18).

4 Cut the wires close to the battery holder with a

pair of household scissors (Fig. 19).

5 Remove the battery holder with the rechargeable

battery (Fig. 20).

6 Use a screwdriver to pry the battery off the

printed circuit board (Fig. 21).

Do not connect the appliance to the mains again after

you have opened it.

Guarantee & service

If you need service or information or if you have a

problem, please visit the Philips website at

www.philips.com or contact the Philips Consumer Care

Centre in your country (you nd its phone number in

the worldwide guarantee leaet). If there is no Consumer

Care Centre in your country, go to your local Philips

dealer.

ENGLISH

2

4222.002.8021.3

Рейтинг

Подробнее об этом руководстве

Мы понимаем, что приятно иметь бумажное руководство для вашего Philips QT4021 Триммер для бороды. Вы всегда можете скачать инструкцию с нашего сайта и распечатать самостоятельно. Если вы хотите получить оригинальное руководство, мы рекомендуем вам связаться с Philips. Возможно, они смогут предоставить оригинальное руководство. Вы ищете руководство для вашего Philips QT4021 Триммер для бороды на другом языке? Выберите предпочитаемый язык на нашей домашней странице и найдите номер модели, чтобы узнать, есть ли она у нас в наличии.

Технические характеристики

Все инструкции для Philips Триммеры для бороды
Больше руководств Триммеры для бороды

Часто задаваемые вопросы о Philips QT4021 Триммер для бороды

Наша служба поддержки выполняет поиск полезной информации по изделиям и отвечает на часто задаваемые вопросы. Если вы заметили неточность в наших часто задаваемых вопросах, сообщите нам об этом с помощью нашей контактной формы.

Сопутствующие товары

Руководство

Philips BT9280 Триммер для бороды

Руководство

Philips QT3900 Триммер для бороды

Руководство

Philips BT1214 Триммер для бороды

Руководство

Philips QT4001 Триммер для бороды

Руководство

Philips BT7512 Триммер для бороды

Руководство

Philips QG3340 Multigroom Триммер для бороды

Руководство

Philips QT4003 Триммер для бороды

Руководство

Philips QT4022 Триммер для бороды

Связанные категории