Руководство Philips HD4603 Чайник

Руководство

HD4666, HD4665, HD4603, HD4602 4222 001 972712 ENGLISH

Introduction

.

Dear customer, thank you for buying a Philips kettle. In these instructions for use you

will find all the information you need to enjoy your kettle as long as possible.

General description

.

1) On/off switch

2) Pilot light

3) Lid

4) Spout

5) Water-level indicator

6) Base

7) Scale filter

Important

.

Read these instructions for use carefully before using the appliance and save them for

future reference.

◗ Check if the voltage indicated on the base of the kettle corresponds to the

local mains voltage before you connect the appliance.

◗ Only use the kettle in combination with its original base.

◗ Always place the base and the kettle on a dry, flat and stable surface.

◗ Keep the cord, the base and the appliance away from hot surfaces.

◗ Do not use the appliance if the mains cord, the plug, the base or the appliance

itself is damaged.

◗ If the mains cord is damaged, it must always be replaced by Philips, a service

centre authorised by Philips or similarly qualified persons in order to avoid a

hazard.

◗ Do not immerse the appliance or the base in water or any other liquid.

◗ The kettle is only meant for boiling water. Do not use it to heat up soup or

other liquids or jarred, bottled or tinned food.

◗ Boiling water can cause serious burns. Be careful when the kettle contains hot

water.

◗ Never fill the kettle beyond the maximum level indication. If the kettle has

been overfilled, boiling water may be ejected from the spout and cause

scalding.

◗ Do not open the lid while the water is boiling. Be careful when you open the

lid immediately after the water has boiled: the steam coming out of the kettle

is very hot.

◗ Avoid touching the body of the kettle, as it gets very hot during use. Always

lift the kettle by its handle.

◗ Keep the appliance and its cord out of the reach of children. Do not let the

mains cord hang over the edge of the table or worktop. Excess cord can be

stored in or around the base of the appliance.

◗ Never fill the kettle below the minimum level to prevent the kettle from

boiling dry.

◗ HD4603 and HD4666: this rapid-boil kettle can draw up to 13 amps from the

power supply in your home. Make sure that the electrical system in your

home and the circuit to which the kettle is connected can cope with this level

of power consumption. Do not let too many other appliances draw power

from the same circuit while the kettle is being used.

◗ Some condensation may appear on the base of the kettle. This is perfectly

normal and does not mean that the kettle has any defects.

◗ Depending on the hardness of the water in your area, small spots may appear

on the heating element of your kettle when you use it. This phenomenon is

the result of scale build-up on the heating element and on the inside of the

kettle over time. The harder the water, the faster scale will build up. Scale can

occur in different colours. Although scale is harmless, too much scale can

influence the performance of your kettle. Descale your kettle regularly by

following the instructions given in the chapter 'Descaling'.

Boil-dry protection

This kettle is equipped with boil-dry protection. This device will automatically switch

the kettle off if it is accidentally switched on when there is no water or not enough

water in it. The on/off switch will stay in 'on' position and the pilot light, if available,

will stay on. Switch the kettle off and let it cool down for 10 minutes. Then lift the

kettle from its base to reset the boil-dry protection. The kettle is ready for use again.

Before first use

.

◗ Remove stickers, if any, from the base or kettle.

◗ Place the base on a dry, stable and flat surface.

◗ Adjust the length of the cord by winding it round the reel in the base. Pass the

cord through one of the slots in the base (fig. 2).

Before using the kettle for the first time:

1 Rinse the kettle with water.

2 Fill the kettle with water up to the maximum level and let it boil once (see

'Using the appliance').

3 Pour out the hot water and rinse the kettle once more.

Using the appliance

.

1 Fill the kettle with water either through the spout or through the open lid

(fig. 3).

HD 4603, HD 4602

1

3

2

4

7

6

HD 4666, HD 4665

MAX

1.7

1.5

1.0

0.5

MIN

L

I

T

R

E

S

3

4

7

6

5

2 3

4

5

Рейтинг

Подробнее об этом руководстве

Мы понимаем, что приятно иметь бумажное руководство для вашего Philips HD4603 Чайник. Вы всегда можете скачать инструкцию с нашего сайта и распечатать самостоятельно. Если вы хотите получить оригинальное руководство, мы рекомендуем вам связаться с Philips. Возможно, они смогут предоставить оригинальное руководство. Вы ищете руководство для вашего Philips HD4603 Чайник на другом языке? Выберите предпочитаемый язык на нашей домашней странице и найдите номер модели, чтобы узнать, есть ли она у нас в наличии.

Технические характеристики

Все инструкции для Philips Чайники
Больше руководств Чайники

Часто задаваемые вопросы о Philips HD4603 Чайник

Наша служба поддержки выполняет поиск полезной информации по изделиям и отвечает на часто задаваемые вопросы. Если вы заметили неточность в наших часто задаваемых вопросах, сообщите нам об этом с помощью нашей контактной формы.

Сопутствующие товары

Руководство

Philips HD4618 Чайник

Руководство

Philips HD9349 Daily Collection Чайник

Руководство

Philips HD4629 Чайник

Руководство

Philips HD4619 Чайник

Руководство

Philips HD4677 Чайник

Руководство

Philips HD4642 Чайник

Руководство

Philips HD4683 Чайник

Руководство

Philips HD9357 Viva Collection Чайник

Связанные категории