Руководство Kärcher K 7 Full Control Plus Мойка высокого давления

Руководство

– 9

 DANGER

Risk of electric shock.

 Prior to all work on the appliance, switch off the ap-

pliance and pull the power plug.

Clean the sieve in the water connection regularly.

 Remove coupling from the water connection.

ATTENTION

The sieve must not be damaged.

Illustration

 Pull the sieve out using flat pliers.

 Clean the sieve under running water.

 Reinsert the sieve into the water connection.

The batteries are depleted if nothing or the

following is shown on the display of the

high-pressure gun.

Two batteries or accumulators of the

size AAA are required.

Illustration

 Push the locking slide.

 Open battery compartment.

 Remove the batteries.

 Insert new batteries and observe the correct orien-

tation of the terminals.

 Close battery compartment.

 Dispose of the used batteries according to the local

provisions.

 DANGER

Risk of electric shock. Turn off the appliance and re-

move the mains plug prior to performing any care and

maintenance work.

Repair work and work on the electrical components may

only be performed by an authorised customer service.

You can rectify minor faults yourself with the help of the

following overview.

If in doubt, please consult the authorized customer ser-

vice.

 Push the lever of the trigger gun, the device will

switch on.

 Check whether the voltage indicated on the type

plate corresponds to the voltage of the mains sup-

ply.

 Check the mains connection cable for damages.

 Motor overloaded, the motor circuit breaker has

tripped.

– Turn off the appliance "0/OFF".

– Allow the device to cool down for one hour.

– Switch on the device and put it into operation again.

If the malfunction occurs repeatedly, have the de-

vice checked by the customer service.

Voltage reduction due to weak mains supply or when

using an extension cable.

 Upon switch-on, push the lever of the trigger gun

first and then switch the power switch to "I/ON".

 Check setting at the spray lance.

 Check water supply for adequate delivery rate.

 Pull out the sieve in the water connection using flat-

nose pliers and clean under running water.

 Remove air from appliance before operation.

Switch on the appliance without connection the HP

hose (max. 2 minutes) and run it until the water dis-

charging from the HP outlet is free of bubbles.

Switch off appliance and reconnect HP hose.

 Clean high-pressure nozzle: Remove dirt and de-

bris from the nozzle bore, using a needle and rinse

through with water from the front.

 Check water flow quantity.

 Dropwise leakage of the device is normal for tech-

nical reasons. If the leakage increases contact the

authorized customer service.

 Turn the 3-in-1 multi jet spray lance to detergent

nozzle "MIX".

 Check whether the Plug 'n' Clean detergent bottle

is placed into the detergent connection facing

down.

 Check / replace the batteries

 Decrease the distance between high-pressure gun

and high-pressure cleaner.

 Couple it to the high-pressure cleaner again.

 Switch off the device and pull the

mains plug out of the socket.

 After 20 seconds, insert the power cord

back into the socket and switch the de-

vice on.

If the malfunction occurs repeatedly, have

the device checked by the customer ser-

vice.

If the pressure regulation on the high-pressure gun is

defective (electronic defect, battery empty, etc.), the

high-pressure cleaner continues operating at the level

that was last set.

To activate emergency operation at the maximum level:

 Switch off the device and pull the mains plug out of

the socket.

 Insert the power cord back into the socket and

switch the device on.

Care and maintenance

Clean the sieve in the water connection

Changing the batteries of the trigger gun

Troubleshooting

Appliance is not running

Appliance does not start, motor hums

Pressure does not build up in the appliance

Strong pressure fluctuations

Appliance is leaking

No detergent infeed

No pressure indicator on the trigger gun

Error messages

Emergency operation

15EN

Рейтинг

Подробнее об этом руководстве

Мы понимаем, что приятно иметь бумажное руководство для вашего Kärcher K 7 Full Control Plus Мойка высокого давления. Вы всегда можете скачать инструкцию с нашего сайта и распечатать самостоятельно. Если вы хотите получить оригинальное руководство, мы рекомендуем вам связаться с Karcher. Возможно, они смогут предоставить оригинальное руководство. Вы ищете руководство для вашего Kärcher K 7 Full Control Plus Мойка высокого давления на другом языке? Выберите предпочитаемый язык на нашей домашней странице и найдите номер модели, чтобы узнать, есть ли она у нас в наличии.

Технические характеристики

Все инструкции для Kärcher Мойки высокого давления
Больше руководств Мойки высокого давления

Часто задаваемые вопросы о Kärcher K 7 Full Control Plus Мойка высокого давления

Наша служба поддержки выполняет поиск полезной информации по изделиям и отвечает на часто задаваемые вопросы. Если вы заметили неточность в наших часто задаваемых вопросах, сообщите нам об этом с помощью нашей контактной формы.

Сопутствующие товары

Руководство

Kärcher HDS 8/18-4 C Мойка высокого давления

Руководство

Kärcher HD 5/12 CX Мойка высокого давления

Руководство

Kärcher K 7 Compact Мойка высокого давления

Руководство

Kärcher HD 6/15 C Plus Мойка высокого давления

Руководство

Kärcher HDS 7/16 CX Мойка высокого давления

Руководство

Kärcher HDS 8/18-4 CX Мойка высокого давления

Руководство

Kärcher HD 10/25-4 S Мойка высокого давления

Руководство

Kärcher K 7.200 Мойка высокого давления

Связанные категории