Руководство Gorenje DK63CLI Кухонная вытяжка

Вам нужно руководство для вашего Gorenje DK63CLI Кухонная вытяжка? Ниже вы можете бесплатно просмотреть и скачать PDF-инструкцию на русском языке. В настоящее время этот продукт имеет 2 часто задаваемых вопроса, 0 комментариев и имеет 0 голосов. Если это не то руководство, которое вам нужно, свяжитесь с нами.

Ваше устройство неисправно, и в руководстве отсутствует решение? Перейдите в Repair Café для получения бесплатных ремонтных услуг.

Руководство

Loading…

L2) When the LED is red (motor off) it indicates the FILTER ALARM. When the LED is green (flashing) it indicates that
the TIMER has been activated with the key E.
FILTER ALARM: After 30h of operation, the LED L2 turns RED. It indicates that the grease filters need to be cleaned.
After 120h of operation, the LED L2 turns RED and flashes; It indicates that the grease filters need to be cleaned and
the charcoal filters replaced. After cleaning the grease filters (and/or replacing the charcoal filters), restart the hour
counter (RESET) by pressing the key E during display of the filter alarm.
Controls shown in Fig. 14: Button A: turns the lights on/off; every 30 hours of operation the corresponding pilot lamp (S)
comes on to indicate that the grease filters must be cleaned; every 120 hours of operation the corresponding pilot lamp
(S) flashes to indicate that the grease filters must be cleaned and the charcoal filter replaced. To restart the hour counter
(RESET), hold the button A pressed down for about 1” (while the pilot lamp S is on). Button B: drives the motor in first
speed (the corresponding pilot lamp comes on); when holding it down for about 1”, the motor cuts out; when pressing the
button a second time (while the pilot lamp is on) , the TIMER is activated and thus the motor stops after 5’ (the pilot lamp
flashes). Button C: drives the motor in second speed (the corresponding pilot lamp comes on); when pressing the button
a second time (while the pilot lamp is on) , the TIMER is activated and thus the motor stops after 5’ (the pilot lamp flashes).
Button D: drives the motor in third speed (the corresponding pilot lamp comes on); when pressing the button a second
time (while the pilot lamp is on) , the TIMER is activated and thus the motor stops after 5’ (the pilot lamp flashes). Button
E: drives the motor in fourth speed (the corresponding pilot lamp comes on); when pressing the button a second time
(while the pilot lamp is on) , the TIMER is activated and thus the motor stops after 5’ (the pilot lamp flashes).
Pay special attention to the grease filters; to remove the filter: push inward on the clamp at the handle and pull the filter
downward. Wash out the filter using a neutral soap. if the model purchased has the controls shown in Figure 13: see the
paragraph “Controls shown in Fig. 13” (“Filter Alarm”). If the model purchased has the controls shown in Figure 11/12: the
grease filter must be cleaned periodically: exactly how often depends on use (at least once every other month). If the
model purchased has the controls shown in Figure 14: the grease filters must be cleaned approximately once every 30
hours of operation (when the light button lamp comes on) - Fig. 14S).
Once the cleaned filters are reinstalled, to reset the counter hold the light button pressed down for about 1”
(Fig.14A) while the corresponding pilot lamp (S) is on. For further information, see the Controls in Fig.14 in the
paragraph entitled “Operation”.
Charcoal filter/s: if using the hood in the filtering hood, the charcoal filter must be replaced periodically. To remove the
charcoal filters, proceed as follows, depending on the model purchased:
- if the hood features round charcoal filters (Fig. 15), remove the charcoal filter by turning clockwise.
- if the hood features a panel type charcoal filter (Fig. 10), remove the charcoal filter by first of all removing the two filter
retainers M.
If the model purchased has the controls shown in Figure 13, see the paragraph “Controls shown in Fig. 13” (“Filter
Alarm”). If the model purchased has the controls shown in Figure 11/12, the charcoal filters must be replaced according
to use: on the average once every 6 months. If the model purchased has the controls shown in Figure14, the charcoal
filters must be replaced each time the light button (Fig.14S) lamp flashes (i.e. every 120 hours of operation).
Lighting:
- To gain access to the bulbs, remove the grease filters as described above and remove the bulbs. Replace only
with CANDLE HALOGEN LAMP - Ø 35mm, E14–220-240 Vac, 28W or INCANDESCENT LAMP-E14–220-240 Vac, 40W
- If the halogen lamps shown in Fig. 16 need changing, slacken the ring nut in an anticlockwise direction and remove the
bulb itself. Replace with the same type of lamp. CAUTION: Do not handle glass bulb with bare hands.
- To change the halogen lamps shown in Fig. 17 open the cover levering from the proper slots. Replace with the same
type of lamp. CAUTION: Do not handle glass bulb with bare hands.
The motor used in this hood features a safety device (thermal cutout) that responds to temperature changes For
accidental reasons or due to installation faults, this device could engage and automatically shut off the motor,
thereby preventing serious damage to the equipment. In such cases, after allowing the motor to cool down, the
hood can be switched on again; the cause of the fault will nonetheless have to be remedied, ensuring installation
has been correctly made and that all the instructions in the Information sheet have been complied with.
Загрузить руководство на русском (PDF, 53.54 MB)
(Помните о необходимости охраны окружающей среды и распечатывайте настоящее руководство только в том случае, если это действительно необходимо)

Loading…

Рейтинг

Сообщите нам, что вы думаете о Gorenje DK63CLI Кухонная вытяжка, оставив оценку продукта. Хотите поделиться вашими впечатлениями от данного изделия или задать вопрос? Вы можете оставить комментарий в нижней части страницы.
Вы довольны Gorenje DK63CLI Кухонная вытяжка?
Да Нет
Будьте первым, кто оценит это изделие
0 голоса

Присоединиться к беседе по данному изделию

Здесь вы можете поделиться тем, что думаете о Gorenje DK63CLI Кухонная вытяжка. Если у вас есть вопросы, сначала внимательно прочтите инструкцию. Запросить руководство можно с помощью контактной формы.

Подробнее об этом руководстве

Мы понимаем, что приятно иметь бумажное руководство для вашего Gorenje DK63CLI Кухонная вытяжка. Вы всегда можете скачать инструкцию с нашего сайта и распечатать самостоятельно. Если вы хотите получить оригинальное руководство, мы рекомендуем вам связаться с Gorenje. Возможно, они смогут предоставить оригинальное руководство. Вы ищете руководство для вашего Gorenje DK63CLI Кухонная вытяжка на другом языке? Выберите предпочитаемый язык на нашей домашней странице и найдите номер модели, чтобы узнать, есть ли она у нас в наличии.

Технические характеристики

Бренд Gorenje
Модель DK63CLI
Категория Кухонные вытяжки
Тип файла PDF
Размер файла 53.54 MB

Все инструкции для Gorenje Кухонные вытяжки
Больше руководств Кухонные вытяжки

Часто задаваемые вопросы о Gorenje DK63CLI Кухонная вытяжка

Наша служба поддержки выполняет поиск полезной информации по изделиям и отвечает на часто задаваемые вопросы. Если вы заметили неточность в наших часто задаваемых вопросах, сообщите нам об этом с помощью нашей контактной формы.

Какое расстояние должно быть между варочной панелью и вытяжкой? Проверенный

Зависит от производителя, но в целом вытяжка должна находиться как минимум на расстоянии 65 см над газовой плитой, и как минимум 50 см над электрической или индукционной. Это необходимо для соблюдения пожарной безопасности.

Это было полезно (1340) Читать далее

Нужна ли мне вытяжка с мотором или без? Проверенный

Вытяжки с двигателем предназначены для вытяжки воздуха наружу. Вытяжка без мотора предназначена для централизованной системы вентиляции. Никогда не подключайте вытяжку с двигателем к центральной системе вентиляции!

Это было полезно (778) Читать далее
Руководство Gorenje DK63CLI Кухонная вытяжка

Сопутствующие товары

Связанные категории

×
Download